|
Post by wychild on Jan 12, 2014 11:56:23 GMT -7
Here is my method and tools for measuring, comparing and selecting, Bullets,cases and for setting up bullet seating for over all length of Cartridges of the selected bullets . Over all length is a subjective measurement, either by measuring from the tip of the seated bullet to the base, or from the Ogive to the base, the latter being the most accurate. Pictured are the tools that I use to perform these measurements. Setup for measuring and comparing bullets and Dial indicator set which includes one .001” and one.0005” dial indicators. Approximate price for the set is $57.00 from Amazon. The set up shown is for comparing and selecting bullets by Ogive length. The bullet is placed in the precision comparator nut. the comparator nut has holes on each flat for different calibers price was $15.00 from Sinclair. Ogive over all cartridge comparison is accomplished with the same set up. Case comparison measurements are done without the nut. I found this setup has sped up selection of components and has in creased the accuracy.
|
|